![]() I will also take a picture of the two stocks side by side along with the amount of the plastic that was cut from the Phoenix. The correct thread and length hex head bolt was purchased at a local ACE True Value hardware store, but I can not remember the exact size used. After that, it was a lot of filing, shaping and constant test fitting.īy not judging the screw hole correctly, so I had to redrill the existing hole with a larger size drill bit and hold it at an angle so the existing hole was opened up oblong. I then used a band saw and removed the unnecessary part of the Phoenix stock where it had been drawn on. ![]() ![]() After I removed the factory stock from the 320, I placed it side by side with the Phoenix and estimated the mounting angle as best as I could by eye, then drew with a pencil where the Phoenix stock needed to be cut off so that the two stocks would match. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |